Using this option all correct data is loaded to the cubes and incorrect data to the error stack. Valid Records Updated, Reporting Possible (Request Green): The erroneous records can be updated using the error DTP. The data will not be available for reporting until the erroneous records are updated and QM status is manually set to green.
Valid Records Update, No reporting (Request Red): Correction would mean reloading the entire data again. Also this request will not be available for reporting. If there is erroneous /incorrect record and we have this option enabled in the DTP, the load stops there with no data written to the error stack. Thus if the data load fails, all the data needs to be reloaded again. Hence for any failed records no data is written to the error stack. Using this option error stack is not enabled at all. It will help in data analyzing for failed data requests. In DTP, it can set in case to store the data temporarily in data loading process of any process like before extraction, before transformations. This option behaves exactly in the same way as explained above. No data transfer delta status in source: fetched This option is used if we want to execute the DTP in dialog process and this is primarily used for debugging.ģ.
No data selected process monitor dtp sap bw serial#
Serial in dialog process (for debugging) (synchronous processing) It processes the data packages in parallel.Ģ. This option is most used in background processing when used in process chains. Serial extraction, immediate parallel processing (asynchronous processing) The various types of processing modes are shown below:ġ.
Processing mode also depends on the type of source. Extraction, transformation, transfer etc). These modes detail the steps that are carried out during DTP execution (e.g. It loads all data/requests from source into target. This can be achieved in 7.xīy putting „No data transfer, delta status in source: Fetched‟.įull: It behaves same like info package with option “Full”. In 3.x, in info package have an option Initialization without data transfer. If selected this option then the DTP will load request by request from source and keep the same request in target. Have to select this option when the number of new requests is more in source and the amount of data volume is more. Get all new data request by request: If don‟t select this option then the DTP will load all new requests from source into a single request. If used these setting then from the second loads it will delete the overlapping request from the data target and keeps only the last loaded request in data target.ī. In case delete overlapping request from data target have to select this option and use delete overlapping request process type in process chain. Only get delta once: It can select this option where the most recent data required in data target. If you selected transfer mode Delta, you can define further parameters:Ī.
0 kommentar(er)
